Description

Heat Transfer Vinyl Iron On Sheet Bundle HTV 12"x10" for T-Shirt Cricut Warm Tips: *We suggest you make a test prior to making sure it is not cutting through the transfer/carrier sheet, just peel a little on edge. This will prevent wasting any full sheet! *If our vinyl can not iron on T-shirt, please check 3 key points: Pressure/Temperature/Time. Increase them and try it again. *Do not use nylon, velvet, acrylic fabrics, leather, which will melt and ruin the material. Cut Setting: For Cricut: Mode: Iron on + Blade: Standard For Silhouette Cameo： Material: Heat Transfer, Smooth Blade: 10 Force: 5 Speed: 5 Passes: 2 Application Instructions (HOME IRON): 1. Set iron dial between Wool and Cotton 2. Cover design with a cover sheet (Teflon Sheet) 3. Place on a flat, hard surface (ironing board not recommended) 4. Press iron with medium/firm pressure (do not slide iron) 5. Press each section of the design for 10-15 seconds, apply design at 305 °F 6. If the area of design lift after application, apply cover sheet and repress for 10-15 seconds 7. Peel carrier cold 8. Cover completed design and press for 5-10 seconds Application Instructions (HEAT Press) 1. Set heat press to 300°F-320°F 2. Pre-heat the garment with medium pressure for 2-3 seconds 3. Apply for transfer as instructed above on garment and cover with a Teflon Sheet 4. Apply medium pressure to the garment for 10-15 seconds 5. Allow the transfer to cool for 45 seconds before peeling off the clear carrier sheet Washing Instructions: 1.Turn the garment inside out. 2.Machine wash COLD with mild detergent. 3.NO bleach. 4.Dry at a normal dryer setting on household machines. 5.Do not dry clean. 6.Instructions apply to the material only, please follow garment washing instructions as well. Note: 1. Please allow 1-3cm error due to manual measurement. 2. The colors may have different as the difference display, please understand.